Faculty Name | Department | Title |
---|---|---|
Sanjay Kumar Mangal | Mechanical Engineering | "Multi-parameter optimization of magnetorheological fluid with high on-state yield stress and viscosity", Journal of the Brazilian Society of Mechanical Sciences and Engineering,Vol 39, No. 10, pp4191-4206, 2017 Authors: Mangal, S.K. and Sharma, V., IF-2.220 |
Sanjay Kumar Mangal | Mechanical Engineering | "Development of continuous flow magnetorheological fluid finishing process for finishing of small holes." Journal of the Brazilian Society of Mechanical Sciences and Engineering 41, no. 12 (2019): 1-13. Authors: Kataria, Mukul, and S. K. Mangal. IF-2.220 |
Sanjay Kumar Mangal | Mechanical Engineering | "Optimal placement of an actuator in a two degrees of freedom system to generate desired vibrations", Microsystem Technologies, Volume 24, Issue 8, pp. 3389-3398, 2018. Authors: Singhal, N., Sharma, M. and Mangal, S. K., IF 2.276 |
Sanjay Kumar Mangal | Mechanical Engineering | "Optimal placement of an actuators for suppressing vibration", International Journal of Science and Technology, Volume 10, Issue 21, June 2017 Authors: Singhal, N., Sharma. M. and Mangal, S.K. Impact Factor (IF)-2.860 |
Sanjeev Kumar | Mechanical Engineering | “Surface roughness and micro-hardness evaluation for EDM with Cu-Mn powder metallurgy tool”, Materials and Manufacturing Processes, Vol. 31 (4), page(s) 514-521, 2016. Authors:Gill, A.S. and Kumar, S. |
Sanjeev Kumar | Mechanical Engineering | “Performance evaluation of the WEDM process of aeronautics super alloy”, Material and Manufacturing Processes, Vol.-33(16), page(s):1793-1808, 2018. Authors:Nain, S.S., Garg, D. and Kumar, S. |
Sanjeev Kumar | Mechanical Engineering | “Modeling and optimization of process variables of wire-cut electric discharge machining of super alloy Udimet- L605”, Engineering Science and Technology, an International Journal, Vol.-20(1),page(s): 247-264, 2016. Authors: Nain, S.S., Garg, D. and Kumar, S., IF-2.670 |
Sanjeev Kumar | Mechanical Engineering | “Evaluation and analysis of cutting speed, wire wear ratio, and dimensional deviation of wire electric discharge machining of super alloy Udimet-L605 using support vector machine and grey relational analysis”. Advances in Manufacturing, Vol.-6(2), page(s):225-246, 2016. Authors:Nain, S.S., Garg, D. and Kumar, S., IF-2.334 |
Sanjeev Kumar | Mechanical Engineering | “Conformal cooling for molds produced by additive manufacturing: A Review” International Journal of Mechanical Engineering and Technology, Vol.-9(1), page(s):1162-1172 2018. Authors:Phull, G. S., Kumar, S, and Walia, R.S. |
Sanjeev Kumar | Mechanical Engineering | “Investigation of Micro-Hardness in Electrical Discharge Alloying of En31 Tool Steel with Cu-W Powder Metallurgy Electrode”, Arabian Journal for Science and Engineering, Vol.-43(3), page(s): 1499-1510, 2017. Authors: Gill, A.S. and Kumar, S. IF-3.171 |